ADIC SNC 5100 - Manual (Page 73)

Fibre Channel MAP 65
6-00020-02
SNC 5100
For more information, see "fcSlotTest [x]" command on page
192.
Step 3. If the test passes, the Fibre Channel optical cable is good.
Go to "Replace Fibre Channel Device" .
If the test fails, go to "Replace Fibre Channel Cable" .
Replace Fibre Channel Cable
Step 1. Replace the cables to the Fibre Channel ports with known good
cables.
Step 2. Perform Health Check.
For more information, see “Perform Health Check” on page 46.
Step 3. View the event log at viewing level 3.
For more information, see Table 9, “Event Viewing Levels,” on
page 42.
Step 4. If problems persist, inform the network administrator that there
seems to be a problem with a device or a host bus adapter.
If problems are gone, exit this MAP.
Step 5. Replace external devices that are attached to the Fibre Channel
ports.
Go to "Replace Fibre Channel Device" .
Replace Fibre Channel Device
The device that needs to be replaced is one of the following:
• Fibre Channel HBA
• Fibre Channel Switch
• Fibre Channel Hub