Restoring normal mode, Special procedures, Health check – ADIC SNC 5100 User Manual
Page 196: Manual health check
SNC 5100
188
Special Procedures
6-00020-02
If the command prompt displayed on the service terminal is not
diagmode >
, enter the
diagBoot
command.
Step 7.
Wait for the SNC 5100 to reboot.
Step 8.
At the
diagmode >
prompt, proceed with the appropriate
diagnostic tests.
Restoring Normal Mode
Follow this procedure if the SNC 5100 was placed in diagnostic mode and
needs to be restored to normal operation.
Step 1.
Connect the terminal to the Service Port, if it is not already
connected.
Step 2.
If it is not already on, turn on the SNC 5100 and wait for it to finish
booting.
Step 3.
From the service terminal, type the
normalBoot
command.
Step 4.
Wait for the SNC 5100 to reboot.
Step 5.
At the command prompt, continue with the MAP that sent you here.
Special Procedures
This section contains information on special procedures.
Health Check
The Health Check function provides a method to periodically determine the
operational state of an SNC 5100 and its attached interfaces and devices.
Manual Health Check
Health Check is performed manually from the service terminal only if the SNC
5100 is in normal mode.