ADIC SNC 5100 - Manual (Page 23)

Supported Platforms 15
6-00020-02
SNC 5100
SCSI 1-4
For each SCSI channel, the LED will be OFF when no devices have been
detected on the port. It will be ON when a target has been found on the channel.
It will flash when there is activity on the channel. The LED will return to the
OFF state if the channel is reset.
PWR
The PWR (Power) LED will be ON when the SNC 5100 has power. It will
flash if the on-board power sensors determine that any of the required supply
voltages are out of range.
RDY
The RDY (Ready) LED indicates status of Ready. Normally the RDY LED
flashes when the SNC 5100 has finished booting. If the RDY LED remains ON
or OFF for more than a few seconds, it means there is a problem.
The RDY LED will flash rapidly, four times per second, when the SNC 5100 is
running in diagnostic mode.
ERR
The ERR (Error) LED indicates that an error condition exists. This may
indicate such errors as over-temperature conditions, fan stalled or other
internally detected error conditions. See “POST Error Codes” on page 197.
Supported Platforms
The SNC 5100 is a platform-independent product. You can connect a host to
the SNC 5100 after you have installed the appropriate host bus adapter and
drivers. You can also connect host systems with different operating systems to
the SNC 5100 through either SCSI or Fibre Channel.
For a current list of supported platforms, configurations, and host bus adapters,
visit
www.adic.com .