HP Deskjet 990cxi Printer - Manual (Page 5)

5
Printing Basics: Paper Trays
Paper Trays
IN Tray
To print, place paper or other media types in the IN tray. Pull out the
IN tray for easy loading. Be sure to slide the paper guides out of the
way before loading the media print side down. Slide all media as far
as it will go into the IN tray. Once you insert the media you want to
use, slide the paper guides so they rest snugly against the media.
Make sure the IN tray is pushed back in.
OUT Tray
The printer sends finished pages to the OUT tray.
OUT Tray Down – This is the typical position for most types of
printing. The down position also allows single envelope printing.
For information about printing on other media, see “Beyond the
Basics” on page30.
OUT Tray Up – The OUT tray must be in the up position to properly
load banner paper and must remain in the up position to print
banners.
OUT Tray Extension – The OUT Tray Extension should be pulled out
when you are printing a large number of pages. In addition, it must
be extended when you are printing in draft mode to prevent paper
from falling to the floor. To use the OUT Tray Extension, gently pull
out the extension. When your print job finishes, push the OUT Tray
Extension back into its storage slot.
Note: Do not use the OUT Tray Extension with legal-sized paper. It
may cause a paper jam.
Load paper in
the IN tray.
Paper width guide
Paper length guide
IN tray pushed in
IN tray pulled out
Printed media
is sent to the
OUT tray.
Automatic Two-Sided
Printing Module
(see page 20)
Single envelope slot
OUT tray down
OUT Tray Extension