HP Designjet 3D Printer series - Manual (Page 24)

20
Op
era
tio
n
System firmware overview
•
Idle
: If there is no part being built and no part in the build queue, the display will show that
the printer is Idle.
•
Wait for Part
or Start Part: If the printer is in Idle and the build queue is empty, you can set
it to wait for a part. If the printer has a part in the build queue, you can press Start Part to
start a build.
•
Building
: If the printer is building a part, you can choose to pause, set the lights either ON
or OFF, view the print time or material remaining and set the printer to auto power down.
•
Material:
From this section you can load material, unload material or replace material.
•
Standby:
From this section you can set the printer to Standby mode.
•
Maintenance:
From this section you can make changes to the System, Setup or Machine.
Figure 16 Display panel hierarchy
Idle
status
Material Standby Maintenance
System Setup Machine
• Set Network
• Test Parts
• Load Upgrade
• Lights Always On
• Select Language
• Gantry
• Head
• Tips
• Pause
• Lights Off
• Show Time
• Auto Power Down
• Load Material
• Unload Material
• Replace Material
Wait for Part Start Part
Building
status