Material jam – HP Designjet 3D Printer series User Manual
Page 57
53
Tr
oubl
eshooting
Material Jam
Occasionally, material may become jammed in the head. The printer will notify you of a
material jam through a message shown on the display panel. If a material jam is detected,
follow these steps to clear the jam.
1.
From the display panel, press Continue.
2.
Press Maintenance.
3.
Press Machine.
4.
Press Head.
5.
Once in head maintenance mode, remove the head cover by pressing the tabs in and
pulling away from the head. See
Figure 48
Remove the head cover
6.
Inspect tip inlets for material build up see
If there is excess material build up see
“Recovering from loss of extrusion” on page 55
. If there is no excess material build up
close the chamber door and continue.
GLOVES:
The head area is hot. Use leather gloves when working in this area
of printer.
Press tabs in to remove
head cover
Head Cover