Installing tips, Maintenance – HP Designjet 3D Printer series User Manual
Page 47
Advertising
43
M
aintenance
Figure 41
Remove the tips
d.
Repeat for second tip if necessary.
Installing tips:
1.
Place the tip shield on the tip. Be sure to install the proper tip. See
Figure 42.
Figure 42
Tip shield alignment
2.
With gloved hand, insert the new tip into the heater block. With the slotted side towards
the rear of the printer. See
Figure 43.
Pull tips down to remove
Align the tip shield so the slotted end is
facing the back of the printer
Slotted end
Slotted end
Advertising