Maintenance – HP Designjet 3D Printer series User Manual
Page 50
Advertising
46
M
aintenance
e.
When you are satisfied with your X offset value, Select Y and
repeat steps A- D to identify and input the required Y Tip Offset
adjustment.
Figure 45
Example XY Tip Offset Part.
This example requires an adjustment of X = + 2, Y = - 4
5.
Select Done after you have input the X and Y offsets. The printer will return to Maintenance.
Run the XY calibration a second time to be sure the values changed the offset properly.
6.
When finished, press Done until back at Idle.
Advertising