Removing the eeproms from the material guides, Removing the desiccant from the material spool, Removing the eeproms from the material – HP Designjet 3D Printer series User Manual
Page 66
62
Re
cy
clin
g
Removing the EEproms from the material guides
1.
Open the model and support material carriers and remove the material guides.
2.
With a small standard screwdriver, pry the two material guide halves apart. See
Figure 56
Pry the model material guide apart
3.
Recycle the EEPROM per your local electronics recycling guidelines.
4.
Recycle the material guides per your local guidelines. See
Removing the desiccant from the material spool
1.
Remove the excess material from the material spool.
2.
Use a standard screwdriver to pry the desiccant cover open. See
Figure 57
Removing the desiccant
3.
Remove the desiccant and recycle per your local guidelines.
4.
Recycle the material spool per your local guidelines.
Pry apart with a small standard screwdriver
Pry apart with a standard
screwdriver
Remove the desiccant and
recycle. Recycle the
material spool.