HP Designjet 3D Printer series - Manual (Page 33)

29
Oper
at
ion
6. Remove the material carriers by first pushing them in to unlatch and then pulling them
outwards.
7. Place the carrier on a flat stable surface.
8. Open the carrier.
9. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the material
guide. See Figure 21.
Figure 21 Rewinding the material spool
10. Using a cutters, cut the excess 2 inches (50mm) of material from the material guide, leaving
a blunt end.
11. Replace the material spool.
12. Close and latch the carrier.
13. Once the material carriers have been replaced press Load...
14. You can select which carriers you want to load to the head by selecting Next Model or Next
Support
. When done selecting press Load Selected.
15. The printer will now load the selected material bays and prepare the other bays for
automatic loading. After they are done loading and preparing, press Done... the display
will show Wait for Part or Ready to Build.
Material bay LEDs
The table below will show the status indicated by the LEDs.
CAUTION: Do not push the material through the material guide back into the
carrier, doing so can cause material to break or become tangled.
On Material currently loaded to the head
Off No carrier present
Carrier present and ready to be loaded
Blinking Carrier needs replacement (is empty or has an error)