Regulatory and environmental information, Regulatory model identification number, Emc class a warning – HP Designjet 3D Printer series User Manual

Page 73: Fcc statements (u.s.a.), Canada electromagnetic compatibility (emc)

Advertising
background image

69

Suppl

emental Inf

or

m

ation

Regulatory and Environmental Information

Regulatory Model Identification Number

For regulatory identification purposes, your product is assigned a Regulatory Model Number.

The Regulatory Model Number for your product is BCLAA-0903. This regulatory number should

not be confused with the marketing name (such as HP Designjet 3D printer) or product numbers

(such as Z####X, where Z and X are any single letter and # is any number).

EMC Class A Warning

FCC Statements (U.S.A.)

The U.S. Federal Communications Commission (in 47 cfr1 5.105) has specified that the following

notices be brought to the attention of users of this product.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:(1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Shielded cables: use of shielded data cables is required to comply with the Class A limits of

Part 15 of the FCC Rules.

Caution: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment

not expressly approved by the Hewlett-Packard Company may cause harmful interference and

void the FCC authorization to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a commercial environment. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in which case the user will

be required to correct the interference at their own expense.

Canada Electromagnetic compatibility (EMC)

Normes de sécurité (Canada)

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de Classe A prescrites dans le réglement sur le

brouillage radioélectrique édicté par le Ministère des Communications du Canada.

DOC statement (Canada)

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

WARNING:

This is a Class A product. In a domestic environment this product

may cause radio interference in which case the user may be required to take

adequate measures.

Advertising