HP Photosmart C7200 Series - Manual (Page 127)

NOTE: The settings you specify here are only saved on the HP All-in-One. They do
not adjust the settings in the software. You can save your most frequently used
settings by using the software that you installed with the HP All-in-One.
Perform special copy jobs
In addition to supporting standard copy jobs, the HP All-in-One can perform special jobs
such as copying borderless photos and resizing originals.
This section contains the following topics:
• Make a borderless copy of a photo
• Resize an original to fit onto letter or A4 paper
• Resize an original using custom settings
• Crop an original
• Shift the left margin
• Improve the quality of a copy
Make a borderless copy of a photo
For the best quality when copying a photo, load 10 x 15 cm (4 x 6 inch) photo paper in
the photo tray and change your copy settings for the correct paper type and photo
enhancement.
To make a borderless copy of a photo from the control panel
1. Load 10 x 15 cm (4 x 6 inch) photo paper into the photo tray.
2. Load your original photo print side down on the right front corner of the glass.
Position the photo on the glass so the long edge of the photo is along the front edge
of the glass, as indicated by the engraved guides along the edge of the glass.
3. Press Start Copy Black or Start Copy Color.
The HP All-in-One makes a 10 x 15 cm (4 x 6 inch) borderless copy of your original
photo.
NOTE: If you loaded tabbed paper in the photo tray, you can remove the tab
from the copy of your photo once the ink has completely dried.
TIP: If the output is not borderless, set the paper type to Premium Photo, and
then try making the copy again.
Chapter 10
126 Use the copy features
C
opy