HP Color LaserJet 9500 Printer series - Manual (Page 70)

http://www.hp.com/support/lj9500
68 Chapter 4 – Improving print quality Rev. 1.0
6 Slide the brush into the transfer-roller slot until it stops, and then slide the
brush toward you until the brush is almost out of the transfer-roller slot.
CAUTION
Do not pull up or sideways on the brush. Push and pull the brush straight
into and out of the printer.
7 Repeat step 6 three times, and then remove the brush from the printer.
8 Remove the brush from the tongs by raising the snap on the back of the
brush and pulling the brush away from the tongs.
9 Replace the tongs and brush on the inside of the right door.
10 Using one hand to support the underside of the transfer roller, turn the roller
to a 45-degree angle and align the roller with the slot. Slide the roller into
the slot until it stops.
CAUTION
Do not touch the black foam roller, and take care not to scratch the
underside of the image transfer belt as you insert the roller into the printer.
6
8
10