HP Insight Management-Software - Manual (Page 25)

add enet-connection
The -add enet-connection command is used to add a new Ethernet network connection to
an existing server profile in the VC Domain.
NOTE: The maximum number of Ethernet connections that can be added to a server profile
depends on the Virtual Connect firmware version. For more information, see the HP Virtual Connect
Enterprise Manager 7.0 User Guide.
Syntax
-add enet-connection –profilename <profileName>
[-network <NetworkName>]
[–pxe <enabled|disabled|usebios>]
[–speedtype <auto|preferred|custom>]
[–speed <speed>]
Parameters
Table 8 Parameter descriptions for -Add enet-connection
Optional Required Description Parameter
x The name of an existing
profile to which the
connection is added. -profilename
x The name of an existing
network to associate with the -network
connection. If the network
name is not specified, or is
set to unassigned, then
the network will be left
unassigned and can be
assigned later.
x Enables or disables PXE on
the network connection. If -pxe
this value is not specified,
the default will be Usebios.
NOTE: Only one
connection can have PXE
enabled per profile.
add enet-connection 25