HP Insight Management-Software - Manual (Page 35)

Table 12 Parameter descriptions for -set fc-connection (continued)
Optional Required Description Parameter
x
IMPORTANT: The
-bootport parameter is
only required when the
-bootpriority
is set to
either primary or
secondary
.
The target world wide port
name (WWPN) of the
controller interface on the
Fibre Channel storage
target. The port name is a
64-bit identifier in the
format:
NN:NN:NN:NN:NN:NN:NN:NN
-bootport
The designation N stands for
a hexadecimal number.
IMPORTANT: The
-bootport parameter is
only required when the
-bootpriority
is set to
either primary or
secondary
.
The logical unit number
(LUN) of the volume used for
SAN boot. Valid values
include an integer from
0-255 or 16 hexadecimal
digits (HP-UX only). -bootlun
Output
The function returns the result of the set operation or a jobid if –nb is specified.
Examples
•
Change the fabric of a FC SAN fabric connection:
vcemcli -set fc-connection –profilename MyProfile1 -portnumber 2
–fabric SAN_5
•
Set a FC SAN fabric connection to unassigned:
vcemcli -set fc-connection -profilename RedProfile2 -portnumber 2
–fabric ""
•
Change the FC SAN fabric of an FC SAN connection:
vcemcli -set fc-connection -profilename BlueProfile1 -portnumber 2
–fabric SAN_7
•
Change the port speed of an FC SAN connection:
vcemcli -set fc-connection -profilename BlueProfile1 -portnumber 2
–speed 4Gb
Minimum Required Role Based Security
VCEM Group Operator
Remarks
The job status for the jobid can be obtained by executing VCEMCLI with the –show job command
and providing the associated job ID. For more information see
“show job” (page 61) .
set fc-connection 35