HP Insight Management-Software - Manual (Page 48)

Table 20 Parameter descriptions for -set iscsi-boot-param (continued)
Optional Required Description Parameter
x
NOTE: The
-initiatorname
parameter is required if the
-iscsibootparamdhcp
is set to disabled.
Name used for the iSCSI
initiator on the booting
system. The initiator name
length can be a maximum of
223 characters. If the
initiator name string contains
non-alphanumeric -initiatorname
characters, it should be
enclosed in quotes.
x
NOTE: The
-initiatorip parameter
is required if the
-networkparamdhcp
is
set to disabled.
IP address used by the iSCSI
initiator. This value is in
dotted decimal format. -initiatorip
x
NOTE: The -mask
parameter is required if the
-networkparamdhcp
is
set to disabled.
IP network mask used by the
iSCSI initiator. This value is
in dotted decimal format. -mask
x Default IP route used by the
iSCSI initiator. This value is
in dotted decimal format. -gateway
x
NOTE: The -vlanid
parameter is required if the
-networkparamdhcp
is
set to disabled.
VLAN number that the iSCSI
initiator uses for all sent and
received packets. Valid
values include VLAN
numbers between 1 and
4094. -vlanid
x
NOTE: The -targetname
parameter is required if the
-iscsibootparamdhcp
is set to disabled.
Name of the target from
which to boot. The target
name length is of maximum
223 characters. If the name
string contains
non-alphanumeric -targetname
characters, it should be
enclosed in quotes.
x
NOTE: The -targetip
parameter is required if the
-scsibootparamdhcp
is
set to disabled.
Primary IP address of the
iSCSI target. -targetip
x The TCP port associated with
the primary target IP -targetport
address. The default value is
3260.
x Alternate target IP address
for use if the primary port is
unavailable. -targetip2
48 Using VCEM commands