HP Insight Management-Software - Manual (Page 50)

Table 20 Parameter descriptions for -set iscsi-boot-param (continued)
Optional Required Description Parameter
x Allows the iSCSI option
ROM to retrieve the TCP/IP -networkparamdhcp
parameters from DHCP or
through static configuration.
Valid values are enabled
and disabled. The default
selection for this attribute is
disabled
allowing for
static configuration.
x
NOTE: The
-dhcpvendorid parameter
is required if the
-iscsibootparamdhcp
is set to enabled.
String used to match the
value in the Vendor Class Id
field in the DHCP offer
packet when retrieving iSCSI
boot parameters -dhcpvendorid
Output
The function returns the result of the set operation or a jobid if –nb is specified.
Examples
•
Configure basic boot attributes on an iSCSI connection of profile MyProfile1:
vcemcli -set iscsi-boot-param –profilename MyProfile1 –portnumber 1
–bootorder primary -Lun 100 -initiatorname "iqn.2009-
09.com.someorg.iSCSI-Initiator" –initiatorip 192.128.3.1
-mask 255.255.0.0 -targetname "iqn.2009-09.com.someorg.iSCSI-Target"
-targetip 192.128.3.2 –targetport 40000
-authentication CHAP –username SomeUserName
-secret SomePassword123
•
Configure iSCSI Boot attributes to be retrieved from DHCP:
vcemcli -set iscsi-boot-param –profilename MyProfile1 –portnumber 1
-bootorder primary –iscsibootparamdhcp enabled
-networkparamdhcp enabled –dhcpvendorid SomeVendorIDValue
•
Configure CHAPM secret and secret values:
vcemcli -set iscsi-boot-param –profilename MyProfile1 –portnumber 1
-bootorder primary
-authentication CHAPM –username SomeUserName
-mutualusername SomeMutualUsername
-iscsibootparamdhcp enabled
-networkparamdhcp enabled
-dhcpvendorid SomeVendorIDValue
Minimum Required Role Based Security
VCEM Group Operator
Remarks
The job status for the jobid can be obtained by executing VCEMCLI with the –show job command
and providing the associated job ID. For more information see
“show job” (page 61) .
50 Using VCEM commands