HP Insight Management-Software - Manual (Page 78)

Table 36 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
The port speed information could not be retrieved for the
specified connection. Verify the provided network id
corresponds to an existing network. 2657
In the FC SAN connection for interconnect bay , the base
boot configuration is not set. 2658
In the FC SAN connection for interconnect bay , the
maximum number of boot configurations was exceeded. 2659
In the ethernet connection for port , the port speed is
incorrect. Unassigned ethernet connections must have port
speed set to Preferred. 2660
In the Ethernet connection for port , the port speed is
incorrect. The minimum and maximum port speeds cannot 2661
be empty. The minimum must be lower than or equal to the
maximum, and the values must be a multiple of 100 Mb.
In the ethernet connection for port , the port speed exceeds
the maximum allowed port speed for the selected network
(Gb). 2662
In the ethernet connection for port , the port speed is below
the minimum allowed port speed for the selected network
(Gb). 2663
The provided port speed value is not a valid number. 2664
In the FC SAN connection for port number and interconnect
bay , the maximum number of boot configurations was
exceeded. 2674
In the FC SAN connection for port number and interconnect
bay , the specified boot target LUN is invalid. Valid value
is a 3-digit decimal between 0 and 255. 2675
In the FC SAN connection for port number and interconnect
bay , the selected FC SAN fabric does not exist. The FC 2676
SAN fabric must exist in the VC Domain Group the Server
Profile belongs.
In the FC SAN connection for port number and interconnect
bay , the selected port speed is invalid. 2677
In the FC SAN connection for port number and interconnect
bay , the specified boot target WWPN is not well-formed. 2678
Valid formats are xx:xx:xx:xx:xx:xx:xx:xx.
xx-xx-xx-xx-xx-xx-xx-xx, or xxxxxxxxxxxxxxxx, where each
x is a hexadecimal digit.
In the FC SAN connection for port number and interconnect
bay , the specified boot target LUN is invalid. Valid values 2679
are either a 3-digit decimal between 0 and 255, or a 13
to 16-digit hexadecimal between 0 and FFFFFFFFFFFFFFFF.
In the FC SAN connection for port number and interconnect
bay , the selected FC SAN fabric does not have a physical
connection to this port. 2680
Invalid number of WWN addresses in the FC SAN
connection for interconnect bay . VCEM does not support 2681
multiple WWPN addresses per physical port when using
Factory-Default WWN addresses.
78 Error messages