Entering the wwn checksum, Entering the storage system password, Installing hp p6000 command view – HP 6400.8400 Enterprise Virtual Array User Manual
Page 32
3.
Turn the power switch on both controllers on.
NOTE:
Notifications of the startup test steps that have been executed are displayed while
the controller is booting. It may take up to two minutes for the steps to display. The default
WWN entry display has a 0 in each of the 16 positions.
4.
Press
or
until the first character of the WWN is displayed. Press
to accept this character
and select the next.
5.
Repeat
to enter the remaining characters.
6.
Press Enter to accept the WWN and select the checksum entry mode.
Entering the WWN checksum
The second part of the WWN entry procedure is to enter the two-character checksum, as follows.
1.
Verify that the initial WWN checksum displays 0 in both positions.
2.
Press
or
until the first checksum character is displayed. Press
to accept this character
and select the second character.
3.
Press
or
until the second character is displayed. Press Enter to accept the checksum and
exit.
4.
Verify that the default display is automatically selected. This indicates that the checksum is
valid.
NOTE:
If you enter an incorrect WWN or checksum, the system will reject the data and you must
repeat the procedure.
Entering the storage system password
The storage system password feature enables you to restrict management access to the storage
system. The password must meet the following requirements:
•
8 to 16 characters in length
•
Can include upper or lower case letters
•
Can include numbers 0 - 9
•
Can include the following characters: ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ ] ^ _ ` { | }
•
Cannot include the following characters: space ~ \
Complete the following procedure to enter the password:
1.
Select a unique password of 8 to 16 characters.
2.
With the default menu displayed, press
three times to display System Password.
3.
Press
to display Change Password?
4.
Press Enter for yes.
The default password, AAAAAAAA~~~~~~~~, is displayed.
5.
Press
or
to select the desired character.
6.
Press
to accept this character and select the next character.
7.
Repeat the process to enter the remaining password characters.
8.
Press Enter to enter the password and return to the default display.
Installing HP P6000 Command View
HP P6000 Command View is installed on a management server. Installation can be skipped if the
latest version of HP P6000 Command View is running. Verify the latest version at the HP website:
See the HP P6000 Command View Installation Guide for more information.
32
Enterprise Virtual Array startup