HP Officejet J6480 All-in-One Printer - Manual (Page 171)

◦ Inspect the ends of the memory card for dirt or material that closes a hole or
spoils a metal contact. Clean the contacts with a lint-free cloth and small
amounts of isopropyl alcohol.
◦ Assure that the memory card is working properly by testing it with other devices.
• Check the memory card slot
◦
Make sure that the memory card is fully inserted into the correct slot. For more
information, see
Insert a memory card .
◦ Remove the memory card (when the light is not blinking) and shine a flashlight
into the empty slot. See if any of the small pins inside are bent. When the
computer is off, you can straighten slightly bent pins by using the tip of a thin,
retracted ballpoint pen. If a pin has bent in such a way that it touches another
pin, replace the memory card reader or have the device serviced. For more
information, see
Support and warranty .
◦ Make sure that only one memory card has been inserted at a time in the slots.
An error message should appear on the control-panel display if more than one
memory card is inserted.
The device cannot read photos on the memory card
Check the memory card
The memory card might be corrupt.
The device prints half a page, then ejects the paper
Check the print cartridges
Make sure the correct print cartridges are installed and the print cartridges are not low
on ink. For more information, see
Manage the device and Work with print cartridges .
HP cannot guarantee the quality of non-HP print cartridges.
Troubleshoot installation issues
If the following topics do not help, see Support and warranty for information about HP
support.
• Hardware installation suggestions
• Software installation suggestions
Hardware installation suggestions
Check the device
•
Make sure that all packing tape and material have been removed from outside and
inside the device.
• Make sure that the device is loaded with paper.
• Make sure that no lights are on or blinking except the Ready light, which should be
on. If the Attention light is blinking, check for messages on the device control panel.
Troubleshoot installation issues 167