HP Officejet J6480 All-in-One Printer - Manual (Page 183)

Prepare the device for shipment
If after contacting HP Customer Support or returning to the point of purchase, you are requested
to send the device in for service, make sure you remove and keep the following items before
returning your device:
•
The print cartridges
• The control-panel faceplate
• The duplexer
• The output tray
• The power cord, USB cable, and any other cable connected to the device
• Any paper loaded in the input tray
• Remove any originals you might have loaded in the device
This section contains the following topics:
• Remove the device control-panel faceplate
• Remove the print cartridges before shipment
• Remove the duplexer
• Remove the output tray
Remove the device control-panel faceplate
Complete the following steps once you have removed the print cartridges.
NOTE: This information does not apply to customers in Japan.
CAUTION: The device must be unplugged before following these steps.
CAUTION: The replacement device will not be shipped with a power cord. Store the power
cord in a safe place until the replacement arrives.
To remove the control-panel faceplate
1. Press the Power button to turn off the device.
2. Unplug the power cord, and then disconnect it from the device. Do not return the power cord
with the device.
Prepare the device for shipment 179