HP Officejet J6480 All-in-One Printer - Manual (Page 71)

Set the fax error correction mode
Typically, the device monitors the signals on the phone line while it is sending or
receiving a fax. If it detects an error signal during the transmission and the error-
correction setting is on, the device can request that a portion of the fax be resent.
Turn off error correction only if you are having trouble sending or receiving a fax, and
you want to accept the errors in the transmission. Turning off the setting might be
useful when you are trying to send a fax to another country/region or receive a fax
from another country/region, or if you are using a satellite phone connection.
To set the fax error-correction mode
▲ Device control panel: Press Fax Menu, open the Advance Fax Setup menu,
and then use the Error correction mode option.
Set the dial type
Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is
Tone. Do not change the setting unless you know that your phone line cannot use
tone dialing.
NOTE: The pulse-dialing option is not available in all countries/regions.
To set the dial type
▲ Device control panel: Press Setup, press Basic Fax Setup, and then use the
Tone or Pulse Dialing option.
Set the redial options
If the device was unable to send a fax because the receiving fax machine did not
answer or was busy, the device attempts to redial based on the settings for the busy-
redial and no-answer-redial options. Use the following procedure to turn the options on
or off.
•
Busy redial: If this option is turned on, the device redials automatically if it
receives a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the device redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is OFF.
To set the redial options
▲ Device control panel: Press Setup, press Advance Fax Setup, and then use the
Busy Redial or No Answer Redial options.
Set the fax speed
You can set the fax speed used to communicate between your device and other fax
machines when sending and receiving faxes. The default fax speed is Fast.
Change fax settings 67