EOTech CNVD-T2 Clip-On Night Vision Device - Thermal 2 - Manual (Page 40)

2-18
2.18 RETICLE (RET)
Activating the RET menu item allows for repositioning the
boresight reticle and toggling it on or off.
Once selected, the sub-menu shown in Figure 2-9 will
appear in the eyepiece display. If in ZOOM 2X mode, P2X
will be displayed in lieu of POS.
Figure 2-9. Menu - Reticle Sub-Menu.
EXIT Sub-Menu Item
Activating the EXIT sub-menu item returns the display to the
Main Menu.
POS (or P2X) Sub-Menu Item
Activating the POS (or P2X) sub-menu item allows for
adjusting the position of the reticle in the eyepiece display.
• Adjustments are made using the UP / DOWN / LEFT
/ RIGHT buttons. When adjusting reticle position,
AZ (azimuth) and EL (elevation) values appear in
the eyepiece display as shown in Figure 2-10. The
numbers represent “clicks” of the reticle. Azimuth
and elevation values can rapidly be returned to 0 by
pressing the UP and DOWN buttons or the LEFT
and RIGHT buttons simultaneously.
• When in ZOOM 1X mode, the reticle moves in
2-pixel increments each time the UP / DOWN / LEFT
/ RIGHT buttons are pressed. The reticle is moved
in 1-pixel increments when in ZOOM 2X mode. See
section 2.23 for click equivalents and zeroing
information.
EXIT POS OFF