EOTech CNVD-T2 Clip-On Night Vision Device - Thermal 2 - Manual (Page 47)

2-25
2.23 ALIGNMENT / ZEROING PROCEDURES
(Continued)
4. Mount the target on an “E” silhouette or other suitable
surface at 25 meters.
5. Mount the CNVD-T2 to the weapon.
6. Turn on the CNVD-T2 using the startup procedures in
section 2.11.
7. Turn the boresight reticle on via the system menu and
align the reticle with the center of the target per section
section 2.18.
8. Fire a 3-round shot group and note the center of the shot
group relative to the designated strike point.
9. Adjust the position of the reticle to move the center of the
shot group to the designated strike point.
10. Fire another 3-round shot group and again observe the
center of the new shot group relative to the designated
strike point.
11. When 2 out of 3 rounds are in the designated strike
zone, the CNVD-T2 is aligned with the rail of the host
weapon.