Anritsu S251C - Manual (Page 38)

Chapter 3
Getting Started
Introduction
This chapter provides a brief overview of the Anritsu Site Master. The intent of this chapter
is to provide the user with a starting point for making basic measurements.
Power On Procedure
The Anritsu Site Master is capable of up to 2.5 hours of continuous operation from a fully
charged, field-replaceable battery. Built-in energy conservation features allow battery life to
be extended over an eight-hour workday.
The Site Master can also be operated from a 12.5 Vdc source (which will also simulta-
neously charge the battery). This can be achieved with either the Anritsu AC-DC Adapter
(P/N 40-115) or 12.5 Vdc Automotive Cigarette Lighter Adapter (P/N 806-62). Both items
are included as standard accessories (see Chapter 1).
To power on the Site Master:
Step 1. Press the
ON/OFF front panel key (Figure 3-1).
The screen displays the Anritsu logo, the Site Master model number, and the
firmware version. The Site Master then takes about five seconds to perform a se-
ries of self-diagnostic and adjustment routines, then displays:
Step 2. Press
ENTER to continue.
If ENTER is not pressed, the Site Master will continue after a 10 second time-
out. The Site Master is now ready for operation.
3-1
3
HOLD
RUN
START
CAL AUTO
SCALE
SAVE
SETUP RECALL
SETUP
LIMIT MARKER
SAVE
DISPLAY RECALL
DISPLAY
PRINT
MODE FREQ/DIST AMPLITUDE SWEEP
SYS
ENTER
CLEAR
ESCAPE
ON
OFF
/
1 2
4
5 6
7 8
9 0
3
+ -
.
Site Master S251C
ON/OFF
KEY
Figure 3-1. Site Master On/Off Key