Administer communication manager, Administering an s8300 primary controller – Avaya S8300 User Manual
Page 206
Installing a new G700 without an S8300 using the Gateway Installation Wizard
206 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Note:
Note:
Avaya P330 Stack Processors now support a "Faststart" or "Portfast" function,
because the 802.1w standard defined it. An edge port is a port that goes to a
device that cannot form a network loop.
To set an edge-port, type set port edge admin state module/port
edgeport
.
For more information on the Spanning Tree CLI commands, see the Avaya P330T User’s Guide
(available
Administer Communication Manager
!
Important:
Important:
The administration procedures in this section are done on the media server that
is the primary controller for the new G700 you previously installed. This primary
controller may or may not be the S8300 you installed in the G700.
The primary controller for the G700 you are installing must be administered to enable
communication between the primary controller and the G700. The administration differs
somewhat depending on whether the primary controller is an S8300 or the primary controller is
an S8400, S8500, or S8700-series Media Server.
Perform one of the following two administration procedures in this section:
●
Administering an S8300 primary controller
●
Administering an S8400, S8500, or S8700-series primary controller
Administering an S8300 primary controller
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface to:
●
Assigning Node Names and IP Addresses for the LSPs
●
●
Associating LSPs with Network Regions
●
●