Electrix Repeater - Manual (Page 13)

ACOUSTIC GUITA R
Here's a basic setup to get an acoustic guitar up and running with Repeater - without the need of any help from your
"pocket protector" friendsÉ
Making a Connection
Plug in your guitar here.
Connect the optional Digitech FS-300 or a single momentary footswitch to engage/disengage the Record function
here.
Connect Repeater's outputs to your monitoring system.
ELECTRIC GUITA R
Now for the guitar player for whom effects have become an integral
part of their sound... Try integrating Repeater in this format:
Using an amp without an effects loop
You can plug Repeater into the guitar input of your amp if you take
the following precautions:
¥Turn down the Input Level to at least half of what you usually
run. Repeater's output is at line level, and this is substantially hot-
ter then the average guitar.
¥ Use the clean channel of your guitar amp. If you try to run
Repeater into a high gain or lead channel you will most likely be
unhappy with the unnecessarily noisy results.
¥To get distorted or lead sounds try using one of the many avail-
able distortion pedals or a tube preamps before connecting to
your Repeater.
English... 13
GETTING STARTED
1
1
2
2
3
3
Trigger Record
If you don't have a foot switch you may benefit
from using Repeater's handy Trigger Record fea-
ture. Trigger Record will set Repeater to start
recording as soon as signal is present at the
audio input.
To set Repeater for Trigger Recording:
á Press and hold Stop and press Record
á Repeater's Record LED will flash indicating
that it is armed and ready for recording
á Start playing
As soon as Repeater detects audio at the input it
will start recording.