Electrix Repeater - Manual (Page 22)

LO O P B R O W S I N G
Loops are arranged in a continuous sequence, with allowance for gaps if
loops have been deleted. The browser indicates internal loops with a " ", CFC
loops are indicated simply with the numbers, " ". Once you browse to the
end of the set of internal loops there will be a final blank internal loop. Then
the external loops on the compact flash card will be displayed with the
numbering starting again at 1. The CFC Indicator displays card activity: Green
for reading, Red for writing.
Note: One empty loop will always be shown at the end of the internal and external sequences to provide a
location for the creation of a new loop.
LOOP CUEING
If Repeater is currently playing a loop, you can use the Loop knob to select a new target loop number (if not the
current loop number). The new loop needs time to load (about a half a second), so prepare a little early for your loop
transition. Repeater tells you when the new loop is locked and loaded by adding a row of dots under the flashing
loop number. Pressing Play will then engage the auto loop transition. Repeater will wait and quantize the start of
the new loop to the end of the playing loop. The play light will flash until the cued loop begins playing. This facili-
tates seamless loop transitions. If you press Play at any time after the first press (while the play light is flashing) the
new loop will start playing immediately and the display will stop flashing. Pressing Stop will stop the current loop
leaving the unit cued and ready to start playing the new loop.
English... 22
THE TRANSPORT
Card loop
Internal loop