Electrix Repeater - Manual (Page 20)

0% Fe e d b a c k
0% feedback will completely erase the original loop track after the completed overdub cycle. This differs from
Replace mode in that Replace will mute the track during the record cycle. In Overdub, at 0% feedback ,the record
destination track will not be muted during the record cycle.
UNDO /REDO
Repeater features one level of Undo for overdubbing operations. Additionally you can Redo what you just undid, and
then carry on to Undo the Redo if you just canÕt make up your mind.
E R A S E
Erase lets you erase any or all tracks within a loop even while the loop is playingÉ
¥ Press and hold the Erase/UNDO button until the display changes to
look like " " and the Track Select and Erase/UNDO
buttons all flash in unison.
¥ The track select buttons will flash only for full tracks, thus in the example shown, you have a loop with four full
tracks.
¥You can select tracks to erase by pressing the Track Select buttons.
¥ Press Erase/UNDO to erase the selected tracks, Stop will take you out of Erase mode without erasing any-
thing.
¥ Erasing all tracks will completely erase the loop.
R E S A M P L I N G / B O U N C I N G
Once you've built up a multitrack loop, you can bounce it down to one or two tracks.
Resampling will cement any modifications you've made to your loop, including pitch
shift, track slip, pan, level, FX and tempo. Resampling can bounce the contents of all
four tracks down to a mono or stereo pair of tracks. You can only bounce down to a
stereo pair if one is already made. You cannot record a stereo pair over two mono tracks.
To Bounce (Resample) TracksÉ
¥ Set the Levels, Pan, Pitch and FX Inserts just how you want it to sound
for the new resampled track.
¥ Use the Track Select buttons to select the track(s) you wish to record to.
¥ Press Resample. The display will show " "
¥ Use the Track Select buttons to select the tracks you wish to be
a part of the new mixed track(s).
¥ Press Resample again to confirm your settings.
¥ Now press Record to engage the resample. Repeater will stay in record and play until you press Record
again. If you press Record before an entire loop cycle is completed then the record light will begin to flash.
DonÕt panic. Resample needs to record through one entire loop cycle . When the Resample operation is com-
plete the Record light will stop flashing and youÕre done. Pressing the Record button before the loop is fin-
ished is a good way to automate the resampling to a single loop cycle.
English... 20
RECORDING LOOPS