Electrix Repeater - Manual (Page 8)

English... 8
FRONT PANEL
1
2
3
4
5
6
7
8 9 1 0
1 1 1 2 1 4 1 5
1 6
1 7
Input Level - controls the input level to Repeater.
Set this control so that the input level indicator is
Orange most of the time, and rarely clips (goes red).
Instrument Input - a high-impedance input opti-
mized for instrument level sources. When a cable is
plugged into this input, the rear inputs are disabled.
Loop - selects the current loop.
Trim - allows the length of a loop to be modified
either by bar or in 1/100ths of a second. This is use-
ful for trimming an 8-bar loop down to 4 or for over-
riding the LPAª function to manually trim the loop.
See LOOP EDITING for details.
Multiply Loop - lets you multiply out your loop.
With Multiply Loop, you can overdub an eight bar
progression over a 1 bar drum loop. See LOOP EDIT-
ING for details.
Repeater's Display indicates the status of four crucial
parameters:
Loop - shows the current loop number (internal
memory loops have a little ' in front of the number)
Bar - when stopped, the bar display shows the loop
length (in bars). During an initial record it shows esti-
mated beats. While playing or overdubbing this dis-
play shows the current bar.
Beat/Div - shows the time signature of the current
loop while stopped, and counts beats while in Play or
Record.
BPM - indicates the current tempo (Beats Per Minute)
Compact Flash Card Slot - insert a Type 1 CFC here.
The CFC is slotted so that the card can only be
plugged in right side up. Check our website for CFCs
that will work. On the first insertion, Repeater will
format the CFC for you. See FILE MANAGEMENT for
more information.
UNDO/ Erase - a single press will UNDO the last
operation or overdub. Pressing and holding will put
you in the ERASE mode, where tracks or the entire
loop can be selected for erasing.
Copy - makes a duplicate of the current loop in any
available loop location. Copy can be used to make
multiple revisions on a single bed, or to copy materi-
al stored internally to the CFC. Press and hold COPY
to see remaining record time.
Overdub - sets Repeater's record mode. When the
Overdub indicator is lit, the recording will be mixed
together with any existing material on a given track.
Alternatively Replace mode is available to replace the
content of the selected track when recording is
engaged. Replace mode is active when the Overdub
indicator is off. See RECORDING LOOPS for details.
Reverse - reverses the direction for both Recording
and Playback. See RECORDING LOOPS for details.
Stop - stops playback or record operations.
Sleep Mode - press Reverse and Stop at the
same time and hold for 3 seconds to enter the ener-
gy saving sleep mode. You will not lose any of the
data stored in internal or external memory. To revive
press any button.
1 3
1
2
3
4
5
6
1 0
1 1
1 2
1 3
9
8
7