Electrix Repeater - Manual (Page 36)

SYNCING REPEATER TO POPULAR SEQUENCERS/DAWÕS
P r o t o o l s
Syncing to Protools is a two step process. First, if you are
using a Mac, you must set up OMS to acknowledge Repeater
and its characteristics. In the Studio Setup create a device
that looks like this: (see Opcode for OMS instructions)
Now in Protools under
the MIDI menu, select
MIDI Beat Clock. Enable
Beat Clock, and select
your MIDI Interface.
Now Repeater will sync
to the tempo map in
Protools.
C u b a s e
Syncing to Cubase is also simple. First, if you are
using a Mac, you must set up OMS (see above).
(This assumes you have a MIDI interface). Then you
will need to setup your synchronization inputs and
outputs. Go to the Synchronization window under
the Options menu. Select your input and output
device. Set the tempo base to MIDI Clock. Select
your MIDI clock input source as your MIDI inter-
face port. For the Sync out select your MIDI inter-
face port.
Double clicking on the ÒClickÓ button in the trans-
port will open the ÒMetronomeÓ window. Disable
MIDI Click by unchecking the ÒMIDI ClickÓ box.
Now Repeater will sync to Cubase.
English... 36
MIDI