Aalborg Vortex Insertion - Manual (Page 60)

55
NOTE: Each Alarm Event can be individually masked (disabled) using
Event Reg Mask menu selection (see Figure 5.14). If alarm event is
masked (disabled) it will not be registered in the Event Register Status
even actual event has occurred.
,
In the example shown below, event 1 with LCD bit code 2 (High Flow Alarm) and
event 10 with LCD bit code A (Totalizer#2 exceed set event volume limit) have
occurred since the last reset.
In order to reset (clear) Event Register press Ent button. Following screen will
appear just for two seconds.
If ENTER is pressed again, the description for each error is displayed:
If during these two seconds user will press Ent button again, the Alarm Event
Register will be cleared.
b) Alarm Events List
This menu selection provides list of the descriptions and corresponding LCD bit
code for all supported events.
Event Reg Status
. . . . . . . . . . . . . . . .
Event Reg Status
. . 2 . . . . . . . A . . . . .
Press Ent key to
Clear events Reg
Events List
Press Enter Key