Anthem Audio D2 - Manual (Page 31)

23
Example 1: Select a source for the ZONE2 Timer:
• Enter the setup menu. Go to SET TIME / TIMERS and press SELECT.
• Press the button until you reach SET ZONE2 TIMERS.
• Press SELECT. The SET ZONE2 TIMERS submenu will appear.
• Press the button until you reach SOURCE.
• Use the buttons to change to desired source.
• Press BACK to leave this submenu and return to the SET TIME/TIMERS menu.
To have the Timer turn on to a Preset Station, do the following from the SOURCE menu line:
(setting Preset Stations is explained in section 4.4.1)
• Use the buttons to change to “Last Stn”.
• Press SELECT to highlight “Last Stn”.
• Use the buttons to select an FM • AM Preset. These scroll from AM 1-1 to AM 1-6 then from
FM1-1 to FM3-6 and back to “Last Stn”.
• Press BACK once you have selected a preset.
The Timer submenu setup procedure is the same for MAIN, ZONE2, and ZONE3.
Example 2: Change ZONE2, TIMER2 to come on Weekdays at 7:30 AM.
• Enter the setup menu. Go to SET TIME/TIMERS and press SELECT.
• Press the button until you reach SET ZONE2 TIMERS.
• Press SELECT. The SET ZONE2 TIMERS submenu will appear.
• Press the button to reach TIMER 2.
• Use the buttons to change to “Week”.
• Press the button until you reach WEEKDAY ON.
• Press SELECT. The hour is now highlighted. Use the Master Control Knob or the buttons to set
the hour to “7” AM. (Continuing through “12” will advance the AM/PM settings.)
• Press the button. “00” minutes will be highlighted.
• Use the Master Control Knob or the buttons to set the minutes to “30”.
• Press BACK to leave this submenu and return to SET TIME/TIMERS menu.
When scrolling between 11 PM and 12 AM settings, the display shows “--:--”. Timers set in the “--:--”
position will be skipped. For example, to set the Timer to only turn on, set the Off time to “--:--”. To set
the Timer to only turn off, set the On time to “--:--”.
3. SETUP
continued …