Anthem Audio D2 - Manual (Page 39)

31
Procedure for Manual Test Sequence:
• Enter the setup menu. Go to LEVEL CALIBRATION and press SELECT.
• Use the buttons to set NOISE SEQUENCE to Manual.
• Press the buttons to go from speaker to speaker.
• As each speaker plays, use the buttons to adjust its loudness relative to other speakers.
• Press BACK to stop the test noise.
Procedure for Auto Test Sequence:
• Enter the setup menu. Go to LEVEL CALIBRATION and press SELECT.
• Use the buttons to set NOISE SEQUENCE to Auto.
• Press SELECT to start the automatic sequence.
• As each speaker plays, use the buttons to adjust its loudness relative to other speakers. After
you make an adjustment, the next speaker will play.
• Press BACK to stop the test noise.
3. SETUP
continued …