Anthem Audio D2 - Manual (Page 50)

42
3.12 DISPLAYS / TIMEOUT
This menu allows you to configure on-screen display, front panel display, and selection time.
Main / Z2 On-Screen Output:
Lets you select the outputs that display on-screen information, or Bypassed, which turns the on-screen
display off. If you choose Bypassed, you will have to rely on the front panel display. If you are using S-Video
inputs and prefer the appearance of the HD characters, select HD Only – the HD characters will be used if
a video signal is present.
Main / Z2 On-Screen Info:
Select the path adjustments that are shown by the on-screen displays. For example, if ZONE2 is set up with
an IR repeater for the remote control and you are using the processor in the MAIN room, you may not want
to see information about ZONE2. On the other hand, you may want to see the ZONE2 information, for example,
while adjusting ZONE2 yourself from the MAIN room.
Main / Z2 On-Screen Position:
Allows you to position the on-screen display to reduce the chance of it interfering with the on-screen display
positions of other video components (e.g. satellite receiver’s status info). Choose from Bottom, Mid, or Top.
Main / Z2 On-Screen Color:
If the on-screen display of the setup menu appears unstable, it could be that your display is not synchronizing
to the blue (factory default) background color. You can change the background color to one that your display
can synchronize to – gray and magenta are also available.
Main / Z2 Video Mute Color:
For when there’s no video input, select the “no signal” output – gray, blue, or magenta screen.
3. SETUP
continued …
12. DISPLAYS / TIMEOUT
a. MAIN OS OUT: S-V + HD
b.MAIN OS INFO:All Zones
c.MAIN OS POS'N: Bottom
d.MAIN OS COLOR: Blue
e.MAIN VID MUTE: Gray
f. Z2 OS OUT: S-V Only
g. Z2 OS INFO: Z2 Only
h. Z2 OS POS'N: Bottom
i. Z2 OS COLOR: Blue
j. Z2 VID MUTE: Gray
k. FP WAKE-UP: Up 1
l. DISPLAY TIMEOUT: 5 s