Anthem Audio D2 - Manual (Page 85)

77
5. REMOTE CONTROL CUSTOMIZATION
continued …
5.5 PROGRAMMING MACROS
Macros are used to execute multiple functions with one key press, such as powering the processor, cable
box, and display On at the same time. Up to 32 commands can be programmed.
Programming a Macro that works regardless of control mode setting:
1. Press and hold LEARN until the LED flashes twice.
2. Press 9, 9, 5.
3. Press the key you want to use to activate your macro (e.g. Power).
4. Enter the command sequence that you want the macro to execute.
5. To exit, press and hold LEARN until the LED flashes twice or wait 10 seconds.
To clear the macro, repeat the steps above but skip step 4.
Programming a Macro that works in one control mode:
1. Press the control mode key.
2. Press and hold LEARN until the LED flashes twice.
3. Press 9, 7, 8.
4. Press the key you want to use to activate your macro (e.g. Power).
5. Enter the command sequence that you want the macro to execute.
6. To exit, press and hold LEARN until the LED flashes twice or wait 10 seconds.
To clear the macro:
1. Press and hold LEARN until the LED flashes twice, then release.
2. Press 9, 7, 8.
3. Press the control mode key where you programmed the macro.
4. Press the key that was programmed to activate the macro.
5. To exit, press and hold LEARN until the LED flashes twice or wait 10 seconds.
5.6 RESETTING THE REMOTE CONTROL
To erase user memory, press and hold LEARN until the LED flashes twice, then press 9, 8, 0. To reset MAIN,
Z2, or Z3 control mode, see the beginning of Appendix B.
If your remote control has stopped working, try resetting it before contacting technical support.