Anthem Audio D2 - Manual (Page 62)

54
4.7 BASS / TREBLE / BALANCE
To change the Bass, Treble, or Balance of:
• MAIN – All Speakers Simultaneously: Press BASS, TREBLE,
or BALANCE, then adjust.
• MAIN – Fronts Only: Press FRONTS, press BASS, TREBLE, or
BALANCE, then adjust.
• MAIN – Center Only: Press CENTER, press BASS or TREBLE, then adjust.
• MAIN – Surrounds Only: Press SURR•REARS, press BASS, TREBLE, or BALANCE, then adjust.
• MAIN – Rears Only: Press SURR•REARS twice, press BASS, TREBLE, or BALANCE, then adjust.
• ZONE2 or ZONE3: Press ZONE2 or ZONE3, press BASS, TREBLE, or BALANCE, then adjust.
• HEADPHONE: Press FRONTS• twice, press BASS, TREBLE, or BALANCE, then adjust.
Pressing BYPASS disables the adjustment. Bass/Treble does not apply to sources set to Anlg-Dir.
4.8 SURROUND MODES
A surround mode is signal processing that enhances original source material.
Surround modes fall into two main categories – those that apply to stereo source
material and those that apply to multichannel source material.
By default, all surround speakers are used except with 1.0-channel sources –
after finding your preferences, change presets in the mode presets menu.
Surround modes do not apply to sources set to Anlg-Dir.
With analog input there is no way for a processor to detect how the source material was encoded.
Stereo Source Material:
This includes analog stereo, digital PCM stereo, and Dolby Digital 2.0 source material. Surround modes can
be applied to provide up to 7.1 channels of output. They are described later in this section. Each source
memorizes its mode setting, so you can, for example, set TV to AnthemLogic-Cinema, and CD to
AnthemLogic-Music.
5.1- and 6.1-Channel Source Material:
The processor engages decoding according to the format that you select on each DVD.
Once the processor’s display shows the format, you can select additional processing described throughout
this section. Your selections are memorized by format and by source.
Why isn’t my processor detecting the sound format that I’m trying to play?
A connection carries one format at a time and the processor plays exactly what it gets. If the connection
is coaxial, optical, or AES/EBU make sure the source’s setup menu is set to leave Dolby Digital and DTS
unchanged (Bitstream) if it is an SD-DVD player or cable/sat box, otherwise output will be 2.0-channel
PCM! You must also select the soundtrack that you want to hear from each disc’s menu, or after the
movie starts by pressing AUDIO on the player’s remote control.
HDMI audio on a Blu-ray or HD-DVD player should be set to PCM or Auto in the player’s menu.
4. OPERATION
continued …
BASS TREBLE BALA NCE
DY NAMICS
ENTER M 0
MODE
INPUT
F
THX
9
TO
NE BYPASS
MOD