Anthem Audio D2 - Manual (Page 42)

34
3. SETUP
continued …
Scaler Input (MAIN only):
Assign which input is used by the video processor when the source is selected – any HDMI, Component
video, S-Video input, or “None”. Before setting this, be sure that you have read section 2.1. Note that if
S-Video is selected, the input connection is the one specified in S-VIDEO IN. To increase seeking speed for
the seek function in section 4.4, set this to None if the source does not use video processing.
Component, S-Video, Composite Video Inputs:
Assign which video input (or None) is used for unprocessed video switching when the source is selected,
including in ZONE2, ZONE3, and REC.
Audio In (MAIN only):
There are three input types to choose from – Digital, Analog-DSP, and Analog-Direct. After highlighting
AUDIO IN use the
buttons to select an input format.
In Digital and Analog-DSP, all channels are upsampled to 24-bit / 192 kHz ensuring the finest
in high-end sound reproduction. This applies even when the input is Dolby Digital or DTS.
• Dig (Digital): Choose any HDMI, coaxial, optical, or the AES/EBU connection. Any digital input can
be assigned to multiple sources. This allows, for example, two setups for the same DVD player –
one for DVDs using DVD1 source setup, and the other for CD music using CD source setup. Note
that Dolby Digital and DTS are transmitted only through a digital connection.
• Anlg-DSP (Analog with Digital Signal Processing): If you want your subwoofer to play from an
analog L/R input, use this setting. Analog input is converted to digital using the processor’s high-end
A/D converters – this enables bass management, time alignment, surround mode, Anthem Room
Correction, bass/treble, lip-sync delay, and THX. These are also available for the 6-Ch input. With
the bass management and time alignment, sound quality from DVD-Audio or SACD is improved
compared to Anlg-Dir mode.
• Anlg-Dir (Analog-Direct): The preamp plays the traditional role of switching inputs and adjusting
levels. All digital processing is bypassed.
Auto Digital (MAIN only):
If set to Yes, the input type switches to Digital when sensing a digital clock signal from a source and to
Analog-DSP when no clock signal is present. This feature is useful with older digital cable boxes that use the
digital output for digital channels and analog output for analog channels.
Example: Change SAT1 Digital Input to optical.
• Make sure satellite receiver is connected to OPT1 and playing.
• Enter the setup menu. Go to SOURCE SETUP and press SELECT.
• Press the button until you reach SAT1 and press SELECT.
• Press the button until you reach AUDIO IN.
• Use the buttons to change to OPT1 (sound will now be heard).
• Press BACK to leave the submenu and return to the main menu.
HDMI 6-Channel Map: (MAIN only, for DVD-A format only):
If you hear channels coming out of the wrong speakers, for example the dialog coming out of the right
surround, change HDMI 6CH MAP to the setting that makes each channel come from the correct speaker.