Alpine INA-W910 - Manual (Page 65)

65
-EN
The clock indication on the monitor display is turned on or off
respectively.
Setting item: Clock
Setting contents: OFF / ON
• The clock of the unit will be automatically updated according to the
data that the Navigation System provides, and cannot be adjusted
manually.
• If the GPS antenna is not connected correctly, the clock indication on
the unit may be wrong because the time information cannot be
received. In this case, it is suggested to set “Clock” to “OFF”.
This unit is equipped with a demonstration function capable of showing
basic operations of respective sources on the monitor display.
Setting item: Demonstration
Setting contents: OFF / ON
• The demonstration operation is automatically repeated until the
function is turned off.
Setting item: Beep
Setting contents: OFF / ON
• This setting is unavailable for the navigation mode.
About the button sounds setting of navigation mode, refer to “Button
Sounds” on page 36.
Scroll display is available if CD text, folder name, file name or tag
information is entered.
Setting item: Auto Scroll
Setting contents: OFF / ON
• The display scrolls on the unit when the screen is filled up.
• Song, artist and album name, etc. scrolls when an iPod/iPhone is
connected.
• Short/Long Station name, Song, Artist, and album name scrolling are
displayed in HD Radio mode.
You can adjust the brightness of the button lighting at night with the
dimmer.
Setting item: Key Dimmer Level
Setting level: -2 to +2
System Setup Operation
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [ ] on the main source screen.
The Setup Select screen is displayed.
3
Touch [ ] of System Setup.
The System Setup screen appears.
4
Touch [ ] or [ ] etc. of the desired item to change
its setting.
Setting items:
Remote Sensor * / Camera IN / AUX1 IN / AUX2 IN / AUX Out /
BLUETOOTH IN / Optical Out / Rear Source *
* Displayed only when AUX Out is ON.
5
Touch [ ] to return to the previous screen.
Touch [ Exit ] to return to the main source screen that was
displayed before the setup operation was started.
• Immediately after changing the settings of System Mode (while the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
Displaying the Time
Demonstration Function
ON: Turns on the demonstration mode to show the basic
operations.
OFF: Turns off the demonstration mode.
Sound (Beep) Guide Function
OFF: Deactivate the Sound Guide mode. The sound guide
beep will not be produced when a soft or a unit button is
pressed.
ON: Activate the Sound Guide mode.
Setting the Scroll
OFF: Turns off the Auto scroll mode. Scroll display is done
once as a track is changed.
ON: Turns on the Auto scroll mode. Scroll display is repeated
as long as the mode is turned on.
Adjusting the Dimmer of Button Lighting at
Night
SYSTEM Setup
To display the System Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the System mode operation has been
released. Engaging the parking brake can reactivate the System
Setup Menu, as long as the car’s ignition has not been turned off.
It is not necessary to repeat the above procedure (1 through 3) of
“To display the System mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the System mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of System Setup. Refer to each section for details.