Alpine INA-W910 - Manual (Page 66)

66
-EN
For remote control operation, the remote sensor of the external device
(monitor, etc.) can be switched, as you prefer.
Setting item: Remote Sensor
Setting contents: Front / Rear
• When an optional DVD changer or DVD player is connected, and the
remote control sensor is set to Rear, some soft button operations
( [ ] STOP, etc.) cannot be performed. In this case, set the remote
control sensor to Front.
With an optional camera connected, video of camera is output to the
monitor. Depending on the connected camera, set this item to “Direct”
or “RCA”. For detailed information of the optional camera, refer to the
table on page 66.
Setting item: Camera IN
Setting contents: OFF / Direct / RCA
• By shifting to reverse (R), the rear pictures are output.
This function is effective when the reverse wire is properly connected.
After setting this item to Direct or RCA, touch [ ] of Camera IN, the
following further setting items can be adjusted.
Rear camera guide line display setting
You can set whether the rear camera guide line is displayed or
not.
Further Setting item: Guide Line
Setting contents: OFF / ON
Adjusting the Rear Camera Guide line
You can adjust the rear camera guide line position.
Further Setting item: Guide Line Adjustment
1
Touch [ ] of Guide Line Adjustment.
The guide line adjustment screen is displayed.
2
Touch the guide pylon you intend to adjust.
3
Touch [ ], [ ], [ ] or [ ] to adjust the position of
the guide.
After moving the guide, when you touch [ ], the guides in
the horizontal row are aligned in a row.
4
After the adjustment is completed, touch [OK].
You can touch [Reset] during adjustment to return to the
default adjustment.
Selecting the camera
Depending on the connected camera, set this item to “Topview”,
“Front” or “Rear”.
Setting item: Camera Select
Setting contents: Topview * 1 / Front / Rear
About the setting information of the optional Alpine camera, refer
to the table below.
* 1 This setting item is prepared for the Alpine Topview camera.
This setting item is displayed only when Camera IN is set to RCA,
refer to page 66.
* 2 Any front or rear camera which has the RCA video output can also
be connected to this unit.
*
3
If both front camera HCE-C200F and rear camera HCE-C200R are
connected, please set “Camera IN” to “RCA” and “Camera Select”
to “Rear”.
Turning View Change Function ON/OFF
Depending on the connected camera, the view angle of camera
may be changed.
When a camera with View Change Function is connected, set
this item to ON.
Setting item: View Change Func.*
* Displayed only when Camera IN is set to Direct and the rear camera
is selected, refer to page 66.
Switching the function of the remote
sensor
Front: The remote sensor of this unit is effective.
Rear: The remote sensor of the external monitor
connected to AUX OUT of this unit becomes
effective. The remote control operates the source
connected to the AUX OUT terminals.
Setting the Camera Input
OFF: The Camera mode cannot be used.
Direct: Use when the optional direct camera is connected.
RCA: Used when connecting to an optional camera with
RCA output connector.
Direct Camera RCA Camera * 2
Front HCE-C200F * 3
—
Rear
HCE-C300R
HCE-C117D
HCE-C200R * 3
HCE-C115