1 head resistance – HID FARGO HDP5000 User Guide User Manual
Page 22
Advertising
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Page 22 of 100
July 2013
© 2012, 2013 HID Global Corporation. All rights reserved
Figure 2 - Advanced Settings
•
Setting column: Displays the type of setting
•
Default column: Displays the default setting value
•
Current column: Displays the current setting value
Change the Current value by clicking the field to activate the control and enter the new
value.
•
Apply button: Applies changed values.
•
Restore Defaults button: Restores default values.
4.7.1 Head Resistance
This value is factory set. If the main circuit board or the printhead is replaced, adjust this
number.
• Locate the Printhead Setting Number on the bottom of the Printhead.
• The number reads R=XXXX.
Advertising