HID FARGO HDP5000 User Guide - Manual (Page 59)

July 2013 Page 59 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
4.14.1 Using the Click and Drag capability
Click and drag the corners and the sides of an area to change size and location of area.
• The Horizontal, Vertical size and X, Y coordinates update accordingly.
Click and drag the area to change the location.
• The X, Y coordinates update accordingly.
4.14.2 Selecting “inches or mm” radio button
Select from the
inches or mm radio button to change the measurement type. (Note: This is
similar to the choice on the Card tab.)
• The inches radio button displays the area size and the location in inches.
• The mm radio button displays the area size and the location in mm.
4.14.3 Using the Add and Delete buttons
Step Procedure
1 Use the
Add button for these capabilities:
• Add an area default sized to .2 (.2 at location “0” with focus on the added area).
• Add multiple areas in the same location with the same affect (as if there were only one area).
(
Note: Intersecting/overlapping areas do not cancel each other out; instead, they act as one
area.)
2 Using the Delete button to delete the area with focus from the graphic.
4.14.4 Selecting the Full Card
Step Procedure
1 Select the Full Card option to print the resin black (K) Panel for all black found within all areas of the
image, as shown below.
• The Card image becomes fully black.
• The resin prints anywhere for black.
• The Add and Delete buttons become inactive and are grayed out.
• The Defined Area object size and location scroll controls become inactive and are grayed out.
• The inches and mm dials become inactive and are grayed out.
4.14.5 Selecting the Defined Area(s)
Step Procedure
1 Select the
Defined Area(s) option to print the resin black (K) Panel for all black found only in an area or
areas defined, as shown below.
• The card image becomes white with the grid and one area (available for the User to start with).
• The defined areas print black with resin.
4.14.6 Selecting the Undefined Area(s)
Step Procedure
1 Select the
Undefined Area(s) option to print the resin black (K) Panel for all black found only in the
space outside the areas defined, as shown below.
• The card image becomes black with the grid and one area (available for the User to start with).
• The defined area does not print black with resin.