33 mag flipper angle offset, 34 fluorescent heat offset, 35 warming delay time – HID FARGO HDP5000 User Guide User Manual
Page 32: 36 enable ribbon and film saving, 37 transfer image length, 38 transfer cooling delay, 39 hologram film transfer release tension, 40 enable alternate transfer release, 41 proximity encoder card offset
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Page 32 of 100
July 2013
© 2012, 2013 HID Global Corporation. All rights reserved
4.7.33 Mag Flipper Angle Offset
This option changes the angle of the Flipper Table. Increasing the flipper angle rotates the
flipper table clockwise. The Mag Flipper Angle Offset is factory setting. Do not change without
a technician.
4.7.34 Fluorescent Heat Offset
Use this setting to adjust how dark or light the fluorescent (F) panel is printed. The value has a
range of +/-20.
4.7.35 Warming Delay Time
Use this setting to adjust how much additional time (in minutes) the printer waits after the
transfer roller reaches temperature before beginning transfer. The value has a range of 0 to
20.
4.7.36 Enable Ribbon and Film Saving
This setting enables power up ribbon/film savings. When enabled the ribbon and film
will not skip to a new set of panels after a power up. Cover open/close behavior is
unaffected, so upon a cover close the ribbon and film will skip a set of panels.
0 – disabled/1- enabled.
4.7.37 Transfer Image Length
Use this setting to adjust the length of the image on the card during transfer. The value has a
range of -10 to +10. An increase in the number increases the length of the image.
4.7.38 Transfer Cooling Delay
Use this setting to adjust the delay (in seconds) before transferring the second side of the
card. The value has a range of 0 to 180. An increase in the number increases the length of the
delay in seconds.
4.7.39 Hologram Film Transfer Release Tension
Use this setting to adjust the back tension of the film during the release phase when
holographic film is used. An increasingly negative value increases the back tension. Higher
back tension can fix trailing edge flash.
4.7.40 Enable Alternate Transfer Release
Use this setting to enable/disable the alternative transfer release routine. When enabled, this
routine can improve smudging on cold printers.
4.7.41 Proximity Encoder Card Offset
Use this setting to fine tune the card position when docking a card into the prox encoder in
Bay 2. The setting adjusts the number of steps out from a fully docked position that the card is
placed.