HID FARGO HDP5000 User Guide - Manual (Page 57)

July 2013 Page 57 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
4.13.1 Selecting the Lamination Position
Step Procedure
1 Use the
Lamination Position control to adjust the horizontal position of the PolyGuard
Overlaminate. (
Note: This control functions in the same manner as the Image Position controls,
except only the horizontal position of the overlaminate requires adjustment.)
• To adjust the Lamination position, click the Horizontal adjustment arrows.
• To move the overlaminate more toward the card output side of the Printer, enter a positive
number.
• To move the overlaminate more toward the card input side of the Printer, enter a negative
number. (
Note: The adjustment arrows point in the direction the patch will move on the card.
The maximum value for the Horizontal adjustment is ±100 Pixels (10 Pixels = about .03/.8mm)
The default is 0.)
4.13.2 Adjusting the Lamination Speed - Transfer Dwell Time
Step Procedure
1 Adjust the
Transfer Dwell Time to control the Lamination Dwell Time or throughput speed of a card
in seconds per inch and the Lamination Temperature.
• Default = 2.0 seconds per inch
• Upper Limit = 5.5 seconds per inch
• Lower Limit = 0.8 seconds per inch
4.13.3 Selecting the Lamination Side dropdown menu
Step Procedure
1 a. Select
No Lamination if you do not want to use the Printer's built-in Laminator.
b. Select
Laminate Front Side, Laminate Back Side, Laminate Both Sides or Laminate
Opposite Sides to specify the side(s) of the card to laminate.
4.13.4 Selecting the Lamination Type
Step Procedure
Select one of the
Lamination Type options, according to which type of Lamination media is
currently installed. The Driver supports two types of overlaminates: Film, Lamination and
PolyGuard Lamination. Custom versions of each type are also available.
• Select the Clear Lamination option if the Thermal Transfer Film Overlaminate type is
installed in the Lamination Module.
• Select the 0.6 PolyGuard Lamination option or 1.0 PolyGuard Lamination option for either
patch thickness. (
Note: These require different heat settings and Lamination speeds. Select
the appropriate option according to the thickness of the PolyGuard material you are using.)
• Select Registered Film Lamination if you have a registered thermal transfer film.
• PolyGuard Alternating Patch and Holographic Film Lamination are options.
4.13.5 Selecting the Defaults button
Step Procedure
1 Click
Default to return the Transfer Dwell Time and Transfer Temperature to the Default settings for
the Lamination Type (being used).