Rmc 7152 – Acnodes RMC 7152 User Manual
Page 43
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
RMC 7152
14” short depth server
RMC 7152
14” short depth server
43
RMC 7152
14” short depth server
6-4
Drive Bay Installation/Removal
Serial ATA Drives: Because of their hotswap capability, you do not need to access the inside of the chassis or power down
the system to install or replace SATA drives. Proceed to the next step for instructions.
DVD-ROM Drive: For installing/removing a DVD-ROM disk drive, you will need to gain access to the inside of the RMC 7152
by removing the top cover of the chas- sis. Proceed to the "DVD-ROM Drive Installation" section later in this chapter for
instructions.
Note: Only a "slim" DVD-ROM drive will fit into the RMC 7152.
SATA Drive Installation
The Serial ATA drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers
also help promote proper airflow for the Serial ATA drive bays. For this reason, even empty carriers without Serial ATA drives
installed must remain in the chassis.
Installing a SATA Drive
1. To remove a drive carrier, first push the release button located beside the drive LEDs, then swing the colored handle fully
out and use it to pull the unit straight out (see Figure 6-3).
2. Install a drive into the carrier with the printed circuit board side toward the carrier so that the mounting holes align with
those in the carrier.
3. Secure the drive to the carrier with four screws, as shown in Figure 6-4.