Rmc 7152 – Acnodes RMC 7152 User Manual
Page 57
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
RMC 7152
14” short depth server
RMC 7152
14” short depth server
57
RMC 7152
14” short depth server
XRemote Access Configuration
Remote Access
This allows the user to enable the Remote Access feature. The options are Disabled and Enabled. If Remote Access is set to
Enabled, the following items will display:
Serial Port Number
This feature allows the user decide which serial port to be used for Console Redi- rection. The options are COM 1 and COM 2.
Base Address, IRQ
This item displays the based address and IRQ of the serial port specified above. The options are COM 1 and COM 2.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection. The options are 115200 8, n 1; 57600 8, n, 1;
38400 8, n, 1; 19200 8, n, 1; and 9600 8, n, 1.
Flow Control
This feature allows the user to set the flow control for Console Redirection. The options are None, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test (POST). Select Always to keep Console Redirection
active all the time after POST. (Note: This setting may not be supported by some operating systems.) Select Boot Loader to
keep Console Redirection active during POST and Boot Loader. The options are Disabled, Boot Loader, and Always.
Terminal Type
This feature allows the user to select the target terminal type for Console Redirec- tion. The options are ANSI, VT100, and VT-
UTF8.
VT-UTF8 Combo Key Support
A terminal keyboard definition that provides a way to send commands from a remote console. Available options are Enabled
and Disabled.
Sredir Memory Display Delay
This feature defines the length of time in seconds to display memory information. The options are No Delay, Delay 1 Sec,
Delay 2 Sec, and Delay 4 Sec.
XHardware Health Monitor
This feature allows the user to monitor system health and review the status of each item as displayed.
CPU Overheat Alarm
This option allows the user to select the CPU Overheat Alarm setting which de- termines when the CPU OH alarm will be
activated to provide warning of possible CPU overheat.
Warning! 1.Any temperature that exceeds the CPU threshold tempera- ture predefined by the CPU manufacturer may result in
CPU overheat or system instability. When the CPU temperature reaches this predefined threshold, the CPU and system
cooling fans will run at full speed. 2. To avoid possible system overheating, please be sure to provide adequate airflow to your
system.