Rmc 7152 – Acnodes RMC 7152 User Manual
Page 45
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
RMC 7152
14” short depth server
RMC 7152
14” short depth server
45
RMC 7152
14” short depth server
Serial ATA Power Cables
SATA power cables should be routed so that they do not block the airflow through the chassis. See the serverboard layout
diagram for the location of the cable con- nections.
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM drive bay. The DVD-ROM drive must have a
"slim" profile to fit into the RMC 7152.
Installing a DVD-ROM Drive
1. Power down the system and remove the AC power cord.
2. Release the retention screws that secure the unit to the rack.
3. Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click").
4. Depress the two buttons on the top of the chassis to release the top cover and at the same time, push the cover away from
you until it stops. You can then lift the top cover from the chassis to gain full access to the inside of the server.
Note: Drives mount on rails and should "click" into place to be correctly and fully installed in their bays. A red mark on a wire
typically designates the location of pin 1.