Power select, Wheel selection, Power select / 36 wheel selection / 36 – CatEye PW-TR100 Power Unit User Manual
Page 36: Menu screen
MODE-
1
MODE-
2
MODE-
2
MODE-
1
36
PW-TR100 : POWER UNIT
Defining remote button setting
* For the basic information on
how to use the menu screen, re-
fer to “Configuring main unit”
on page 35.
Menu screen
Operation Guide
On
OFF
S/S/E
S/S/E
MODE-
1
or
MODE-
2
S/S/E
S/S/E
MODE-
1
or
MODE-
2
Power select
This menu should be set when the optional power unit is used.
NOTE:
• To set the Power select option to ON, you must: attach the main and power unit to the bracket;
connect the battery unit cable into the BATT terminal of the power unit. Check that the termi-
nals of the battery connector and the battery unit are connected correctly.
• Engage the smallest gears at both front and rear so that the tension on the chain can be
minimized.
• Carry out calibration with the gear crank facing downward.
• Do not touch the crank during calibration.
If the setting is tur mned on, calibration starts to check whether or not the power unit is connected. After
calibration has been completed, the software of the main unit is available for the power unit.
Turn on Power select as this option is OFF by default.
NOTE:
• If the original menu screen reappears after an
“Error”
message is displayed, this means that the
power unit is connected incorrectly, or that the user is rotating the pedals during calibration.
• Even if an error occurs and Power select fails, the power unit is available for the main unit. In
this state, however, you cannot measure the power correctly. Specify the Power select option
again to complete calibration.
• If the power sensor has been used for an extended period, power-related values may shift and
affect accuracy. Make sure to carry out calibration periodically using the Power select option
on the main screen. Before important measurements especially, it is recommended that cali-
bration be carried out.
Wheel selection
You can choose between two wheels, A and B.
The initial value for tire size (circumference) B is 2050 mm.
NOTE:
• Before Wheel circumference, it is necessary to stop the measurement and reset all measured
data.
• Not resetting all measured data causes the
“PLEASE rESEt”
message to be displayed, making
selection impossible.
Torque menu screen
Auto-mode menu screen
Power select
menu screen
After calibration, the menu screen reappears automatically.
If calibration is canceled, the
“Error”
message is
displayed to return to the menu screen.
Calibration
(for 10 seconds)
Wheel selection
menu screen
Select