CatEye PW-TR100 Power Unit - Manual (Page 47)

MODE- 1
MODE- 2
MODE- 2 MODE- 1
47
PW-TR100 : POWER UNIT
Power select
Wheel selection
Tire circumference input
Auto-mode
Sound
Date
Setting clock
Manual odometer input
Speed unit
Defining remote button setting
Cadence zone
Heart rate zone
Heart rate sensor ID
Data file
Data storage
PC Link
Torque
Power select
* For the basic information on
how to use the menu screen, re-
fer to “Configuring main unit”
on page 35.
Menu screen
Operation Guide
S/S/E
MODE- 1 or MODE- 2 S/S/E
Data file
You can check and manage data files recorded by the PW100.
Display 1 indicates the remaining amount of storage (%). Display 3 indicates the total number of laps used
in that data file. Display 4 indicates the data file number.
NOTE: • Power-related measurement data are stored in the power unit while other measurement data
are stored in the main unit. Therefore, before deleting data files, make sure to attach the main
unit to the power unit. If data files are deleted using the main unit only, power-related data will
not be deleted, resulting in a malfunction.
If data files are deleted using the main unit only, refer to “Trouble on operation” on page 64.
• To check and use the stored data files, a PC is required.
• When there are no date files recorded ( “F-0” on Display 4), this screen cannot be operated.
Remaining memory
Data file menu
screen
Data file
number
Number of
laps used
Number of
laps used
in file
Memory consumption Recording interval
Alternating data display
Data file check screen
Switch file
File number
Date of ride
Ride time
Ride start time
End
Haert rate sensor ID menu screen
• Checking data files
When the START/STOP/ENTER button is pressed with the “Data file” menu displayed, data files
can be checked.
The screen displays the data file number, recording interval, memory consumption, number of
laps, date and time when the file was recorded, and exercise duration.
To switch the data file number, press MODE-1 or MODE-2.
NOTE: • Up to 99 data files can be stored until the remaining memory is at 0%.
• When the remaining memory reaches 0% while data storge is in progress, your data
file will end at that point. Measurement continues, however, data is no longer stored
in a data file. New data files will not be created.
• If data is downloaded after the power unit is connected to the PC, “data relocation”
occurs. Consequently, the data file in the main unit is deleted.
(This setting can be changed to “data copy”. For further information, refer to “Down-
loading measured data” in the electronic “e-Train Data v3E. pdf” documentation.)