CatEye PW-TR100 Power Unit - Manual (Page 66)

66
PW-TR100 : POWER UNIT
Reference Guide
Battery unit
Battery life: Approx. 3 months when the power unit is used one hour per day.
* The battery life shown in this manual is not definitive and it varies depending on the use environment.
Release the lock of the battery unit and slide the unit downward to remove it from the battery bracket.
Open the upper cap and replace the old batteries with two new ones (AA batteries). Slide the batteries into
the compartment with the + side downward as shown in the illustration, fasten the cap securely, and then
attach it to the battery bracket.
CAUTION ! • While attaching the battery unit, turn the lock so that the unit cannot fall.
• When attaching or removing the battery unit, be careful not to damage the cable.
• If the battery unit is removed, store the unit with the battery connector attached to the
battery bracket.
• Be careful to orient the batteries correctly.
• Do not mix old and new batteries.
• Remove the batteries from the unit whenever you are planning to store the bicycle for
a long period of time or when the batteries are exhausted.
Maintenance
Daily care of the POWER UNIT
• When the main unit, HR sensor, and speed sensor are dirty, wash them with water or wipe them
with a soft cloth dampened with diluted neutral detergent, then wipe with a dry cloth. Do not use
solvents such as paint thinner or rubbing alcohol as they may damage the surfaces.
• The fastening belt absorbs sweat easily, and leaving it as such is unsanitary. Wash with a neutral
detergent.
• Regularly check that the positions of the magnets and sensors are correct.
Spare accessories
AA batteries x 2
Close
Open
#240-2400 Power Unit
#249-9900 Parts kit
#249-9910 Battery unit
Seal